Tag Connect for In-System Programming
You are here:
The Debug Store >
Programmers >
Programmer Adapters and Cables >
Tag Connect for In-System Programming | Tag Connect is a simple and secure way of connecting debuggers, programmers and test equipment to your PCBs. Tag-Connect eliminates the need for a programming or JTAG connector on your PCB by utilising pogo pins housed in a unique, non-reverisble configuration to connect to the target board. |
|
| Tag Connect saves you money! There is no need to fit a connector to your target board and using Tag Connect saves board space. |  |
|
 | Tag-Connect for BDM Interfaces The Background Debug Mode (BDM) interface used with MPC5xx/MPC8xx microcontrollers has 10 signal/ground-pins. This makes Tag-Connect the ideal connection system for such targets.
The TC2050-IDC Tag-Connect cable is avialbe in both locking and non-locking versions and can be used directly with all Macraigor Systems BDM interfaces. |
|
TAG-Connect for 20-pin ARM JTAGMicrocontrollers based on the ARM core most commonly fitted with 20-pin, 0.1" pitch connectors.
Two adapters are available from Tag Connect which allow either one or two 10 way Tag-Connect cables to be used.
Only 7 out of 20-pins are used for JTAG signals, the remainder are either not used (3) or used for signal ground connections. In most cases a single 10 way TC2050-IDC cable can be used with a TP2050-ARM2010 adapter.
If you need to connect all 20 connections, then two TC2050-IDC Tag-Connect cables can be used with a TC-2050-2X10 adapter. |  |
|
