ADC Click Board
The ADC Click Board™ carries the MCP3204 12-bit Analog-to-Digital converter. The Click Board™ is designed to run on 3.3V by default. Place PWR SEL SMD jumper to 5V position if used with 5V systems. It communicates with the target microcontroller over SPI interface.>
- Based on the MCP3204 12-bit Analog-to-Digital Converter (ADC)
- Four single-ended inputs
- 100 ksps max. sampling rate at VDD = 5V
- Uses 3.3V power supply by default
- Supported by all mikroElektronika compilers
- 50 ksps max. sampling rate at VDD = 2.7V
- Industrial temp range: -40
- RoHS compliant
IC/module: MCP3204 Analog-to-Digital Converter
ADC Click is designed using MCP3204, a 12-bit Analog-to-Digital Converter. The MCP3204 is programmable to provide two pseudo-differential input pairs or four single-ended inputs. It establishes communication with the devices using a simple serial interface compatible with the SPI protocol. It is capable of conversion rates of up to 100 ksps.
Why ADC Click is needed'
The ADC Click is needed to provide a link between the analog world of transducers and the digital world of signal processing and data handling. This accessory board allows for multiple connections with the help of its 12-bit ADC that engages itself in quantization of the input and converts the voltage periodically that is sampling the input, thereby facilitating the process of data integration.
The ADC Click Board™ comprises of two zero-ohm SMD jumpers: PWR SEL and REFERENCE. PWR SEL allow the user to select a 5V or 3.3V power supply. The REFERENCE enable user selection of either VCC or 4.096V as the voltage reference.
- ADC Click Board (1)
- 1x8 male headers (2)
- Printed User Manual and Board Schematic (1)