Click Board 2 for PIC32MX
Blend different functionalities together and quickly build new and original gadgets using the Clicker 2 for PIC32MX board. The click board two-seater for PIC32MX is a compact development board driven by a 32-bit PIC32MX460F512L MCU from Microchip, operates at 80 MHz/105DMIPS, and has 512+12KB of program memory and 32KB of RAM. This clicker 2 board includes two MikroBUS sockets that allow user to plug in any two add-on click boards with unique functionalities and features. The board also has two indication LEDs, two general purpose buttons, a reset button, a USB Mini-B connector, a li-polymer battery connector, and an on/off switch. To assist in interfacing with external electronics, a MikroProg connector and a 2x26 pinout is provided.
The user can supply power to the clicker 2 for PIC32MX board with either a Mini-B USB cable or using a Li-Polymer battery, via on-board battery connector. It comes preprogramed with a fast USB HID bootloader, which enable user to load code into it without requiring an external programmer. However, the user can also program the MCU using external programmer using on-board pads for installing a header compatible with the MikroProg for PIC.
An LTC3586-1 power management IC allows charging of a connected battery via USB and delivers 3.3V or 5V to the add-on boards. The MikroBUS host connectors each consist of two 1?.
- Based on the PIC32MX460F512L microcontroller with MIPS M4K core
- Up to 105 DMIPS operation; 80 MHz
- 2 mikroBUS host sockets
- USB Mini-B connector
- 512 KB Flash plus 12 KB boot Flash
- 32 KB RAM (can execute from RAM
- 85 I/O pins
- 16-bit and 32-bit digital timers
- Internal oscillators, 8 MHz, 32 kHz
- SPI, I2C, ADC, UART, RTC, etc.
The clicker 2 for PIC32MX board features a 32-bit MIPS M4K Core PIC32MX460F512L microcontroller with 512KB of Flash and 32KB RAM. It has an integrated full speed USB 2.0. support and is rich with on-chip peripherals. .
The microcontroller used can be programmed in three ways: Using USB HID mikroBootloader; using external mikroProg for PIC32MX programmer; Using external ICD2/3 programmer.
The clicker 2 for PIC32MX can be connected to the power supply in two ways: USB and Battery. When using a Mini-B USB cable, the voltage regulators provide the appropriate voltage levels to each on-board component. The green LED denotes the presence of power supply. When using a Li-Polymer battery, the on-board battery charger circuit allows user to charge the battery over USB connection. The red LED denotes that the battery is in charging state. .
Clicker 2 for PIC32MX Board User Manual
- Clicker 2 for PIC32MX (1)
- 1x26 headers (2)
- 1x5 Header (1)
- Printed User Manual (1)
If you've already bought this product, please sign in and add your own review!