CAN Bus High-Low Converter without Terminator
The Lipowsky IF-CAN-BC-revE02 converter with terminator will enable the user to connect a system with CAN high-speed-interface (CAN-Buslayer ISO-11898 or CAN C) to low-speed fault tolerant (CAN-Buslayer ISO-11519 or CAN B) busses.
- CAN Bus High/Low speed convertor
- Without a CAN Bus Terminator
The IF-CAN-BC-revE01 is plugged into a CAN high speed interface and converts the signals of this interface for compatibility with fault tolerant low speed signal requirements. A DC Voltage from 8 to 36 volts can be connected to pin number 9 of either the low speed or the high speed connector. An internal voltage regulator and decoupling diodes supply the internal circuits with the proper voltage. Note: This unit is fitted with a line termination resistor on the high speed side.
- IF-CAN-BC-revE02 CAN Bus Converter without terminator (1)