The cookie settings on this website are adjusted to allow all cookies so that you have the very best experience. If you continue without changing your cookie settings, we'll assume that you are happy to receive all cookies on our website. However, if you would like to, you can change your settings at any time using the Change cookie settings link in the account menu. 
    
 

Nano Power Click Board

Nano Power Click Board

SKU: MIKROE-3035

Nano Power Click Board | MIKROE-3035
In Stock 1 in stock
Lead Time (if not in stock) 5 working days
Our Price: £13.20
Inc. UK VAT 20.00 %
Quantity

The Nano Power Click BoardÖ is a boost (step-up) DC-DC converter click with extremely high efficiency and very low input voltage, aimed at the low power IoT market and battery-powered sensors and other devices. The input voltage can be very low: the conversion will start for voltages down to 0.95V, providing 5V to the connected load. Once started, the input voltage can drop as low as the 0.4V, depending on the connected load. The onboard DC-DC converter IC uses the pulse frequency modulation control scheme (PFM), that allows high efficiency and low power consumption for a wide range of output currents.

  • Nano Power Click Board (1)

Charger Click Board

The Charger click is an add-on board that comes integrated with two chips, one is a battery charger controller, and the other one is a battery charge monitor. The smaller chip MCP73831 is a miniature single-cell, advanced linear charge management controller that is commonly used is space-conscious and budgeted applications. This fully integrated Li-ion, Li-polymer charge management controller works with a programmable charge current from 15 mA to 500 mA. The larger chip DS2438 is a smart battery monitor, commonly used in portable computers, cell phones, consumer electronics, handheld instrumentation, etc. The board also features an on-board battery connector to facilitate connection. Charger click uses the unique 1-Wire interface, which requires only one port pin, for communication with the target microcontroller. The DS2438 has a unique silicon serial number, which allows several units to work on the same 1-Wire bus.

This permits multiple battery packs to be charged or used in the system simultaneously. It is designed to operate using a 5V power supply source.

MIKROE-2033

£22.00

MIC24045 Click Board

The MIC24045 Click Board is based on the MIC24045 I2C-programmable, high-efficiency, wide input range, 5A synchronous step-down regulator from Microchip.

The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over I2C interface with additional functionality provided by the following pins on the MikroBUSline: RST, INT.

MIKROE-2574

£13.00

MCP73213 Click Board

The MCP73213 Click Board carries the MCP73213 dual-cell Li-Ion/Li-Polymer battery charge management controller with input overvoltage protection from Microchip. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over SPI.


Note: This click is designed to charge a dual-cell Li-Ion/Li-Polymer battery. The input voltage needs to be higher that the voltage of a dual-cell Li-Ion/Li-Polymer battery.

MIKROE-2575

£18.00

More...


Share