PAC1934 Click Board
The PAC1934 Click Board™ carries the PAC1934 four channel DC power/energy monitor from Microchip. The Click Board™ is designed to run on either 3.3V or 5V power supply.
It communicates with the target microcontroller over an I2C interface.
Thew PAC1934 Click Board™ is based on the PAC1934 four channel DC power/energy monitor from Microchip. The Click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over an I2C interface.
How the Click Works
There are four 4-Terminal current sense shunt resistors connected to the current sense amplifier (in the chip). Electricity is brought to shunts via screw terminals. Middle screw connector is GND which can be used for bus voltage monitoring.This Click enables energy monitoring with integration periods from 1 mS up to 36 hours or longer. Bus voltage, sense resistor voltage, and accumulated proportional power are stored in registers for retrieval by the system master or Embedded Controller.
PAC1934 Energy Monitor Features
The PAC1934 is a four channel bi-directional high-side current-sensing device with precision voltage measurement capabilities, DSP for power calculation, and a power accumulator. It measures the voltage developed across an external sense resistor (VSENSE) to represent the high-side current of a battery or voltage regulator. The PAC1932/3/4 also measures the SENSE1+ pin voltages (VBUS).
- PAC1934 Click Board (1)