The SerialFlash Board is an add-on board featuring an EN25F80, 8-Mbit (1024-byte), low-voltage Serial Flash Memory with advanced write protection mechanisms accessed by a high-speed SPI-compatible bus. Various electronic devices and applications use serial-interface memory. Initially, it is used to store preference data and configuration/setup data. Known to be one of the most flexible non-volatile memory modules used today, the Serial memory modules are rated way better than other NVM solutions. The EN25F80 memory module offers a lower pin count, smaller package, lower voltage, and lower power consumption.
The on-board LED indicator denotes the power status of the board. DIP switch allows for selection of communication lines and set which pins are used for MISO/MOSI/SCK. The Serial Flash Board is designed to operate using both 3.3V and 5V power supply.
The Serial Flash Board, with such features, makes an ideal choice for multimedia devices, drives, optical and printing devices.
- 8 Mbit of serial flash memory
- 75 MHz SPI bus interface
- 3.3V or 5V single supply voltage
- IDC10 connector to facilitate connection with peripheral modules
- Supported by all mikroElektronika compilers
- Bulk erase (8 Mbit) in 8 sec
- High performance with 100 MHz clock rate
- Low power consumption
- Uniform sector architecture (256 sectors of 4-Kbyte; 16 blocks of 64-Kbyte)
- Software and Hardware write protection
- Lockable OTP security sector
- Minimum 100K endurance cycle
- Power indicator LED
- RoHS compliant
IC/Module: EN25F80 8 Mbit Serial Flash Memory
The EN25F80 is an 8 Megabit (1024-byte) serial flash memory with 4 Kbytes uniform sector. Driven by SPI-compatible bus, the memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. It can either erase a single sector at a time or a full chip. The module is also configured to write protect all or part of memory using software. .
The Serial Flash Board is connected to a development system using a 2x5 connector CN1 on the add-on board and a 2x5 connector on a development system's port. Based on the development system used, the user can position the appropriate switches on DIP switch SW1 to the ON position. The Serial Flash Board has a jumper J1 that enable the user to select the power supply voltage to be used to power the additional board. .
SerialFlash Board User Manual
- SerialFlash Board (1)
If you've already bought this product, please sign in and add your own review!