SerialFlash PROTO Board
The SerialFlash PROTO Board is an additional board featuring 8 Mbit flash memory that can be used by the microcontroller or some other device. The board features on-board EN25F80 chip that allows the microcontroller to use additional 8 Mbit flash memory space via SPI serial interface.
Designed to fit into all standard prototyping breadboards, the SerialFlash PROTO Board can be used in a wide range of applications and electronics. Previously used to store preference data and configuration/setup data, the serial memory modules are known to be the most flexible non-volatile memory modules used. This memory module works on low power consumption and low voltage, and offered in a compact package with lower pin count. All this makes this board a better choice over commonly used NVM solutions. The SerialFlash PROTO Board supports operation on 3.3V power supply only. It comes with seven connection pads that are unpopulated to allow user to connect the board to the system. It is configured to operate on a 3.3V power supply only.
- Based on the EN25F80 with 8 Mbit of memory and 75 MHz SPI bus interface
- Perfect solution for storing large amounts of data externally
- IDC10 connector to facilitate connection with peripheral devices
- Single power supply operation
- Supported by all mikroElektronika compilers
- DIP switch for selection of communication lines
- Power indicator LED on-board
- 75 MHz (maximum) clock signal
- Use a 3.3V power supply only
IC/Module: EN25F80 8 Mbit, low-voltage Serial Flash Memory
The EN25F80 is a low-power, high performance serial flash memory that allows the microcontroller to use additional 8Mbit flash memory via high-speed SPI serial interface. It is backed with high performance program/erase speed. It has 256 sectors of 4-Kbyte or 16 blocks of 64-Kbyte, where any sector or block can be erased individually. It can sustain a minimum of 100K program/erase cycles on each sector. .
The SerialFlash PROTO Board is connected to other devices through the Serial Peripheral Interface (SPI). It uses a 1x7 connector CN1 for connection with the additional board. Next to the CN1 connector, the board denotes the function of pins provided on the additional board. .
SerialFlash PROTO Board User Manual
- SerialFlash PROTO Board (1)
If you've already bought this product, please sign in and add your own review!