Tag Connect TC2030-MCP-10 Cable
The Tag Connect TC2030-MCP-10 cable is 254mm (10") long; offering the greatest flexibility for hard to reach boards. However, for fast interfaces the shortest cable length is recommended and this should be borne in mind as long cables may prove to be unreliable in a few cases".
- Cable length: 254mm (10)"
- Suitable for Microchip ICD
- Compatible with CCS ICD-U64, Load-N-Go, Mach-X and Prime8 debuggers and programmers
- Compatible with TI's SPY-BI-WIRE interface (with SPY-BI-TAG adapter)
Tag-Connect is a simple and cost effective method of connecting a serial debugger or programmer to a target board. Ease of UseThe standard RJ12 connector simply plugs into your debugger or programmer. The RJ12 connector is used widely with PIC development tools. Save MoneyNo need for expensive and bulky RJ12 connectors on every board for programming and debugging. Tag Connect just 'snaps' into its own special footprint. The cost of this for each board is almost ZERO Save Board SpaceTag-Connect needs a tint footprint - just 58sq mm for the plug-in version. The Tag-Connect footprint can be placed anywhere on your board, not only close to the edge but close to the CPU to keep signal path lengths as short as possible. ReliableTag-Connect uses spring loaded Test pins (pogo), rated at 100,000 cycles. This offers a secure connection, time after time. The cable is rugged, designed for highly repetitive use. FlexibleThe Plug-In (legged) version forms a secure, semi-permanent connection for as long as required.
- Tag Connect TC2030-MCP-10 Cable (1)