Locking Cables

The TC2030-ALT programming cable is a special cable that has a TC2030 “Legged” Tag-Connector at one end and a 10-pin 0.1″ pitch female IDC connector at the other. 

The 10-pin IDC can be plugged directly into some Altera USB Blasters and ByteBlasters.

6-Pin Legged TC2030 Plug-of-Nails™ Cable for use with ARM Cortex processors.

The Tag-Connect TC2030-CTX-20 plug-in cable has a 6-pin TC2030 Tag-Connector and a 20-pin ribbon and ribbon connector that mates with the FTSH-105 style micro-headers used for Cortex Debug Connector used by debuggers such as the IAR i-Jet or the Keil ULINK PRO.

20 pin ARM Cortex cable with 6-pin Tag-Connector for SWD and an additional 10-pin TC2050 connector providing the extended trace signals.

6-Pin Legged TC2030 Plug-of-Nails™ programming cable for use with STM32 processors with STLINK-V3 and STLINK-V3MINI.

Note: This STDC14 cable was previously known as TC2030-CTX-ST14.

This special cable has a 6-pin TC2030 Tag-Connector and a 14-pin ribbon connector that mates with the STDC14 (FTSH-107) style micro-header found on the STLINK-V3 and STLINK-V3MINI providing the signals necessary for the SWD protocol on the STM32 MCU including SWO.

See also the TC2030-CTX-NL-STDC14 “No Legs” version of the cable with footprint that saves over 66% of the board space needed by typical FTSH-107 style micro headers!

If you need all 14-pins connected to your target board see instead the TC2070-IDC-050 cable.

For traditional ARM JTAG solutions using the 20-pin 0.1″ header as found on ST-LINK/V2 or the add-on Mezanine board in STLINK-V3SET see here.

The Tag Connect TC2030-IDC 6-Pin, 6" legged cable with Ribbon connector.

The Tag Connect TC2030-IDC-10 6-Pin, 10" legged cable with Ribbon connector.

6-pin plug-of-nails™ “with legs” to RJ12 programming cable for Microchip ICD debuggers and programmers.

6-pin plug-of-nails™ “with legs” to RJ12 programming cable for Microchip ICD debuggers and programmers.

The Tag Connect TC2030-MCP-10 cable is 254mm (10") long; offering the greatest flexibility for hard to reach boards. 

TC2030 (legged) to SWIM connector for use on ST-LINK/V2 for STM8 MCUs

FTDI’s TTL to USB Serial Converter cable fitted with a TC2030 6-pin “Legged” Tag-Connector  in a choice of voltage/types. 

Please specify the version you need when ordering.